Soft Close Suede Lining For Jewelry Boxes

Soft Close Suede Lining For Jewelry Boxes
Product Introduction:
WINIW supply suede lining for jewelry boxes in 0.5 and 0.8 mm, 137 cm usable, in twenty shades, cut to the box maker's pattern. We have spent nine years on the millimetre that decides how a box feels when it closes. We are expecting your box drawing, the board thickness and the clearance the lid was designed with.
Send Inquiry
Description
Technical Parameters
Material Overview
 

A box closes on a tolerance. Lid clearance, minus board, minus two layers of lining and adhesive, is the gap the air escapes through. Line it thicker than the design allows and the lid binds; line it thinner and the lid lands with a knock instead of a cushion.

 

That is why the same suede comes at 0.5 and 0.8 mm. Half a millimetre is for a lid with a tight shoulder. Eight tenths is for a box that wants a padded face and has the clearance to carry it.

 

Physical Properties & Specifications
 

 

Item Specification
Material Microfiber suede, PU-impregnated
Thickness 0.5 / 0.8 mm
Usable width 137 cm / 54 in
Pile Short, dense, upright
Lid fit Quoted against your box drawing and board
Corner Mitre or gather guidance with each pattern
Recovery Crush tested under the lid pad, per order
Adhesive Low strike-through grade for thin lining
Colour 20 stock shades, or Pantone lab dip
Light fastness EN ISO 105-B02, per order
MOQ 300 linear meters per colour
Packing 20-30 m per roll, PE

 

 

 

01-box-open
02-box-closed
06-colour-range

 

 Product Feature
 

 

 

1.The closing feel is arithmetic.

Send the drawing with the lid clearance marked and we will say which thickness lands the lid on the cushion. It is the cheapest test a programme can run.

2.Four corners decide whether it reads handmade.

A mitre fold doubles the thickness in a 90 degree corner; at 0.8 mm that is a lump unless the corner is relieved. We mark that on the pattern.

3.The lid pad takes the pressure.

A pad sits compressed from packing day, so the pile must lift back when the lid opens.

4.Half a millimetre and glue.

A 0.5 mm lining wicks water-based adhesive, and the tide mark shows on the face a day later. Specify the low strike-through grade, or run a dry film.

 

Contact now

08-detail-montage

 

Industry Applications

 
07-application-scenarios
  • Hinged lid boxes. The hinge edge compresses first, so the lining there is where a box starts to look used.

  • Drawer slide boxes. The drawer runs against the lining on both sides, and a thick lining makes it drag.

  • Two-piece shoulder boxes. The lid skirt hides the join, so the lining has to stop at an exact height or it shows below the shoulder.

  • Book form boxes. The spine folds 180 degrees, and the lining has to take that fold without cracking at the crease.

  • Travel zip cases. A case is squeezed in a bag, so the lining must recover from compression rather than hold the shape of the jewellery.

 

Why Source From WINIW Factory?

 

WINIW operates a primary 50,000-square-meter synthetic leather manufacturing facility in Quanzhou, China. We control the entire production chemistry, from the base polyamide extrusion to the final stain-resistant PU finish. Producing over 20 million meters annually, our ISO 9001 certified lines guarantee strict batch-to-batch consistency regarding thickness tolerances, grain patterns, and BS5852 fire retardancy compliance. By partnering directly with our factory, B2B upholstery buyers bypass trading company markups. We provide rapid 7-day OEM color matching, verified REACH compliance reports, and scalable supply chain stability for your furniture production lines.

Ready to upgrade your upholstery material specifications?

Eliminate cutting scrap and warranty claims caused by inferior PU. Request complete technical data sheets (TDS) and free physical A4 swatch books to test our peeling strength and stain resistance on your own factory floor.

(Email: MKT@MicrofiberLeather.com)

FAQ

 

Q:0.5 or 0.8 mm for my box?

A: Send the drawing with the lid clearance. 0.5 mm suits a tight shoulder; 0.8 mm suits a padded lid with room to close.

Q:Will the lining make the lid bind?

A: Only if it is thicker than the clearance allows. That is arithmetic, not opinion, and we will run it before you cut.

Q:Can you cut to our pattern?

A: Yes. Send the die line, and we will mark where the corners need relieving on 0.8 mm.

Q:Will glue show through half a millimetre?

A: It will on a plain back. Specify the low strike-through grade or a dry film, and test with the adhesive your line runs.

 

Contact now

 

 

 

Hot Tags: soft close suede lining for jewelry boxes, China soft close suede lining for jewelry boxes manufacturers, suppliers, factory

Send Inquiry